Fte maximal EVO SOFT Manual do Utilizador descarregar pdf (Página 5)

Quick start

To summarize the sequence of working is the following one:

1. From EVOSOFT, the different parameters of the meter are selected for

a set of measurements to be carried out. For this purpose, you can use

the Assistant for creation of groups. The assistant will guide us to

create the structure of the measurements, which is the base of the

datalogger. This structure is made of 2 components:

o A set of programs of measurement, where the parameters of

the channels to be measured are specified.

o The different points of measurement, which are the interesting

places to measure the signal.

2. Once the structure of measurements is created, it is dumped from

the computer to the USB device. The memory is then connected to the

meter, and through the command “New measurement” of the “TOOLS

> DATALOGGER” menu, it executes all the programmed

measurement procedures, storing the results in the same USB memory

device.

In the same manner, the meter can import the structure of measurement to

its internal memory, to use it to carry out the measurements, and once they

are over, to export the measurements to the USB memory device. In this

case you might make sure the limitations imposed due to the capacity of

the internal memory of the meter (see manual) that, for instance, does not

allow storing the picture of the programs.

3. The data, figures and pictures gotten, can then be loaded on the

computer again, where EVOSOFT will allow its viewing and

processing. Finally, the software allows generating detailed reports of

the installations, which can be customized by the customer to make

them fit with its needs.

Manual EVOSOFT Rev. 1.5 5

1 2 3 4 5 6 7 8 9 10 ... 33 34

Sem comentários

Fte maximal EVO SOFT Manual do Utilizador Página 5